/**
 @page RSTCU_Peripheral_Reset_Function

 @verbatim
 * @file    RSTCU/Peripheral_Reset_Function/readme.txt
 * @version V1.00
 * @date    2014-06-30
 * @brief   Description of RSTCU Peripheral_Reset_Function example.
 @endverbatim

@par Example Description:

This example describes how to use the peripheral reset function in RSTCU.

@par Directory Contents:

- RSTCU/Peripheral_Reset_Function/main.c               Main program
- RSTCU/Peripheral_Reset_Function/ht32fxxxx_it.c       Interrupt handlers

@par Hardware and Software Environment:
- Refer "ht32_board_config.h" for pin assignment.
- LED1 will be used as the sign to indicate if the GPIO peripheral has been reset. If the LEDs are
  flashing, press key1 to reset GPIO peripheral and LED will then be turned off.
- This example can be run on HT32 Series development board.

@par Firmware Disclaimer Information

1. The customer hereby acknowledges and agrees that the program technical documentation, including the
   code, which is supplied by Holtek Semiconductor Inc., (hereinafter referred to as "HOLTEK") is the
   proprietary and confidential intellectual property of HOLTEK, and is protected by copyright law and
   other intellectual property laws.

2. The customer hereby acknowledges and agrees that the program technical documentation, including the
   code, is confidential information belonging to HOLTEK, and must not be disclosed to any third parties
   other than HOLTEK and the customer.

3. The program technical documentation, including the code, is provided "as is" and for customer reference
   only. After delivery by HOLTEK, the customer shall use the program technical documentation, including
   the code, at their own risk. HOLTEK disclaims any expressed, implied or statutory warranties, including
   the warranties of merchantability, satisfactory quality and fitness for a particular purpose.

 * <h2><center>Copyright (C) Holtek Semiconductor Inc. All rights reserved</center></h2>
 */
